STARTER REMOVAL & MANIFOLD/HEADER PIPE
Posted: Sat Jul 08, 2017 1:21 am
Will the starter come out without having to remove the manifold/header exhaust pipe........please say yes......since I have already been down the road of rebuilding that part......................starter was dragging...than seemed fine......battery is in good condition..........cables are not in condition......thought about trying to replace those first before replacing starter........i have knew starter.........even though don't totally trust it....made in china....I do have some MG's which appears have the same starter.....I think.......the guess the HI-torque starters have that long of a shaft...
On another note replaced speedo cable.....still not not appear to be working....so any ideas if in trans or gauge.........I spun cable just attached to gauge and it seemed to work....but not working once attached to trans...
On another note replaced speedo cable.....still not not appear to be working....so any ideas if in trans or gauge.........I spun cable just attached to gauge and it seemed to work....but not working once attached to trans...