Web Forum for Singer Cars

Steve
I could use one of those covers. I sent you a personal email.
Thanks

While reupholstering the front drivers (left) seat on my 4AD, I noticed the adjustable seat track is missing the rear
roller. Hopefully another Singer owner might have a spare . Getting ready for spring...

I am now getting to the upholstery on my 1953 4 AD, and I was hoping someone could advise on the number and spacing of the front and rear seats pleat lines and spacing. Might as well get the new upholstery as close as I can to the original. From the pics i have, there seems to be 6 pleat seams on th...

I just happen to have mine off at the moment. It is aluminum as Mike said. measures 12.75 mm wide and is 96.5 cm long (38 inches) and is 1.45 mm thick. it bends approx. its width at the center besides bending with the contour of the panel. Hole spacing is approx. 7.6 cm apart with a start of 3 cm fr...

After several attempts and a lot of time and frustration, I have finished what I believe to be a presentable 4AD grille. I used mirror finish stainless steel for the vertical slats, and riveted them to the new top and bottom support plates with stainless rivets. I used my original grille as a patter...

I have noticed a significant side to side flex of the front scuttle panel with a hard pull on the steering wheel, with the car stationary. I realize some flex in expected, however my windshield posts will move a half inch sideways with a good pull on the wheel. Just wanted to ask if this is normal f...

Found It

MG 1948 to 51

I notice the Club Interchange list does not show a suitable interchange for the Lucas 31281 stop lamp switch.
Mine is rough and needs replacing. Any suggestions appreciated. Thanks

OK...I am getting closer. Thank to mark and Mike for their assistance. First thing I did was to confirm Marks measurement for the hood, and it is indeed the correct length. I removed the rad hose and both side rad brackets to allow the rad and shroud to lean in (toward the rad) considerably. This al...

I am having a serious amount of trouble with the fitting of the rad, rad support,hood. I am hoping a fellow Singer enthusiast can shed some light on the problem. The front rad,shell and support were not with the car when I purchased it, so perhaps I have some incorrect pieces for my 53 ADT....the ra...

Does anyone know of an available starter drive which will fit the Lucas starter
on the 4ad.... Thanks and Happy New Year

Has anyone information regarding achieving the proper float level for the Solex 30 ?
Thanks

Ok..so I did my homework and have determined there are indeed 4 parts to these thrust washers.
Now to locate them....

Finally getting my 4AD engine back together, naturally I have forgotten a couple of things. My problem at the moment is the crankshaft thrust washers.I have the two half washers with tabs which fit into the rear main bearing cap. However there appears to be provision for a further "half washer&...

Put me down for one. Thanks