Web Forum for Singer Cars

I'm needing the dynamo itself, the pulley / fan and the adjustment bracket.

That would be great, thank you for your time and effort in looking. I actually had one with my car, but between it going from my garage to a friend's house to start our re-fabrication project and then back to my garage when the engine was delayed in shop, it seemed to go missing. Thank you, Bill

the 4AD engines were all the same, minor improvements in components on the later years but the major components are all the same. A 51 head will fit and work on a 55 and vice-versa. No difference in camshafts either. Now I'm just needing a set (eight) of good rockers. My shop found someone to build...

My circumstance is almost identical to yours. The block and head are at a machine shop getting rebuilt, but the cams are worn too low and the rocker ends are too flat. I going to reach out to the folks mentioned above, but being I'm in the states having things shipped overseas would be my last optio...

GRANT wrote: ↑Mon Jan 03, 2022 1:54 am WOW THAT MAKES SENSE---i HAVE THE ROUND BASE BUT NOT THE ROUND COVER
FOR THE TRUNK LID HANDLE. ANYONE SELL THOSE?

https://www.vintagecarparts.co.uk/produ ... lock-cover

....or you could just replace the bulbs in the trafficators with flashing LEDs from here: http://www.dynamoregulatorconversions.com/festoon-bulbs.php job done! Have you done this Mod on your Singer ? And from that link that's part number 2 ? Haven't got my trafficators working yet, they're a direct...

I had a similar dilemma when I restored my 1952 4AD. I was totally unfamiliar with anything Singer (except sewing machines) when I started my project. When I got far enough along to restore the body, I found slots behind the doors that had been "bondoed" over and had galvanized backing st...

I know an original rubber transmission cover (see below) can't be found.
But does anyone know of an aftermarket one, maybe made of fiberglass or something.

Might want to call Metro as I think they have wrong price on the website https://metrommp.com/clutch_and_brake_pedal_pads_134_wide_x_3_long_pair_cb_98/ Would hope so, $258 for two rubber pedal pads ?? I found some now on the Moss Motor site at $4.99 a set, just no "S" on the pad. And on t...

Did the 4AD come with brake / clutch pedal rubber pads ? Mine are just bare metal. Also looking for a rubber grommet for the space between the car body and the gas filler tube. And this door hardware piece (the male side) that goes on the door, only have the one. IMAG2528.jpg IMAG2527.jpg IMAG2525.j...

I may have info on the links, I will check For the rear mounts, there is a rubber door stopper that works "almost" perfectly, you have to round off a little bit of the top to fit in the cups, I should have the part number for it. DO NOT buy the one below until I verify the part number... ...

Ended up with just using my old spare tire 5.00-16 (Goodyear with the diamond pattern) as my spare. That fits !
Now have and extra brand new 5.00/5.25-16 Avon that cost $219. Thinking about returning it for a refund, but my friend thinks keeping it for a possible switch out if ever needed is best ?